Use a with:
Note: If the "Data" folder is hidden, enable "Hidden items" in Windows Explorer.
Navigate to your Proteus installation directory. This is typically found at: C:\Program Data\Labcenter Electronics\Proteus 8 Professional\Data\LIBRARY (Note: The "Program Data" folder is often hidden by default in Windows)
: Features an onboard multiturn trimpot (potentiometer) to calibrate the analog output range.
This guide assumes you are using (or higher) and have the Arduino library for Proteus installed (you can find instructions online; the library contains the ARDUINO component).
Connect the secondary transformer output to the inverting input (Pin 2) through a resistor. Place the POT-HG in the feedback loop between the output (Pin 1) and Pin 2 to control the gain. Setting Up the Proteus Simulation Environment
Virtual Terminal to display serial monitor text data. OSCILLOSCOPE: To view the input and output waveforms. Schematic Wiring Connections
Connect the analog OUT pin of the ZMPT101B to the A0 analog input pin of the Arduino.
The Alternator might be misconfigured, or the VCC/GND pins lack simulation power properties.
Navigate to the folder where Proteus stores its library models. The path varies depending on your version: