Zkteco Ua300 Factory Reset ⚡

Immediately connect via ZKTeco’s ZKBio Access 3.5 or Attendance Enterprise , change the default IP, set a strong admin password, and re-enroll users. Do not leave the device at factory defaults on a live network.

If you are locked out and cannot use software, you can generate a temporary "Super Password" based on the system time.

❌

Once reset, the initial setup is standard ZKTeco fare.

Carefully remove the battery or use a jumper wire to short the clear CMOS pads (labeled as RST or RESET near the chip) for 10 seconds. Reinsert the battery and close the housing. zkteco ua300 factory reset

If the UA300 is already connected to your local network via TCP/IP, you can use ZKTeco’s official PC software to reset it remotely:

: Enter your admin credentials or default password (often 12345 or 8888 ).

Before resetting your device, it helps to understand what you are working with. The ZKTeco UA300 is a biometric time attendance terminal that stands out for its advanced firmware and user-friendly graphical interface. It’s designed to simplify the tracking of employee hours by recognizing fingerprints and passwords.

Once your ZKTeco UA300 reboots into its factory state, you must reconfigure its core settings to make it operational on your network. 1. Network Settings (TCP/IP) Go to > Network . Immediately connect via ZKTeco’s ZKBio Access 3

, the blue light flashed. The UA300 had surrendered. The admin lock was gone, and Sarah could finally start enrolling her team from scratch, ensuring she was the one holding the master key this time. Quick questions if you have time: Was the story format helpful? Want more technical ZKTeco details? User Manual - zkteco.me

✅

If you are locked out of the menu because you’ve forgotten the admin password, the hardware reset method is your best bet. This process forces the device to revert to factory defaults:

Use a ZKTeco password generator tool (available to authorized installers) to input the device time. ❌ Once reset, the initial setup is standard ZKTeco fare

Press Menu on the device, enter 8888 as the ID, press OK , and then enter your generated super password. 4. Hardware Reset (Tamper Switch Method)

Use a ZKTeco password generator tool or site to create a password based on that time KeySecu .

Press the key on the UA300 keypad to enter the main menu.

: Use the ZKTeco Admin Password Reset Tool or a similar utility. You enter the device time, and it generates a one-time password. Enter Backdoor : Press M/OK . When prompted for the Admin ID, enter 8888 . Press OK and enter the generated temporary password.

If you are resetting this device because you forgot the password, it works perfectly. If you are resetting it to sell the device or repurpose it, ensure you verify that the fingerprint logs are manually deleted to ensure total privacy.

How to Factory Reset the ZKTeco UA300 Time Attendance Terminal