Xycd60 Manual __full__ Link

The relay closes when the voltage is above the upper limit ( cap U cap P ) and opens when it drops below the lower limit ( ) to prevent over-discharging. Quick Setup Guide Set Limits: Long-press the button to enter parameter settings. Use to toggle between cap U cap P (upper voltage limit) and (lower voltage limit). Adjust Values: Short-press to select the parameter, then use to adjust the voltage. Time Control (OP): You can set a specific charging/discharging time ( cap O cap P

As the load consumes power, the voltage drops. When it falls to or below the Lower Limit Voltage ( dn ), the relay trips OFF, severing connection to the load to preserve battery longevity. Wiring and Connections xycd60 manual

The voltage level at which the device stops discharging (in discharge mode) or starts charging (in charge mode). The relay closes when the voltage is above

Apply power to the unit. The LCD should illuminate and display the measured battery voltage. If it shows , the battery is not connected or does not meet the voltage requirements. Adjust Values: Short-press to select the parameter, then