Sup0108 A Deployment Or Update Operation Is Already In Progress Best [work] <2027>

If you are facing the SUP0108 error on your Dell server, try the following fixes in order.

: Avoid running multiple firmware updates simultaneously; allow each job to reach a "Completed" status before starting the next. Job Monitoring : Always check the Lifecycle Log

If you cannot perform a cold boot immediately, the temporary RAM drive created by the installer is designed to clear itself automatically after approximately 18 hours .

: This is the most common workaround to clear stuck states and lockfiles. You can perform a reset through the iDRAC Web Interface or via the physical "i" button on the server. Force Clear the Job Queue If you are facing the SUP0108 error on

This error is a concurrency control mechanism , not necessarily a system failure. It indicates that the Azure Arc agent has locked the local configuration state to prevent corruption. While the error message is technically accurate, it often appears unnecessarily due to "ghost locks" or slow backend synchronization, making it a frequent source of administrator frustration.

: The simplest solution is to wait until the ongoing deployment or update operation is finished. You can monitor the status of deployments in the SCCM console.

: You can reset the iDRAC interface through the web UI under Maintenance > Diagnostics : This is the most common workaround to

By following the solutions above—starting with clearing the RefreshNow flag and escalating to a full SUP reinstall—you can resolve the error in under 15 minutes. More importantly, by respecting the boundary between WSUS (the engine) and ConfigMgr (the manager), you will rarely see this error again.

It looks like you’re referencing an error message similar to:

To resolve this, you generally need to force the iDRAC to reset its state: It indicates that the Azure Arc agent has

Once you have resolved the error, implement these best practices to ensure it never returns:

The iDRAC fans may spin up loudly for a few minutes while the card reboots. Give the system 5 minutes to fully rebuild its UI environment before logging back in. Method 3: Perform a System Cold Boot and Flea Power Drain

Use the RACADM command-line tool with the command: racadm racreset . Clear the Job Queue Stuck jobs can block the update engine. Action: In the iDRAC UI, go to Maintenance > Job Queue .