Rok Power Washer Instructions 【2027】

Switch the power button to . The motor may hum briefly and stop; it will engage fully when you pull the gun trigger. For ROK Petrol Models

Pinpoint stream; removing stubborn rust or concrete stains. Use with extreme caution.

Turn the power switch to the "OFF" position (or turn off the petrol engine). Turn off the main water supply at the faucet. rok power washer instructions

Before connecting your garden hose to the machine's water inlet, run water through the hose for 30 seconds. This flushes out any dirt or debris that could clog the power washer's internal pump filter. Once clear, screw the garden hose into the water inlet. Step 4: Purge Air from the System

Turn the home water tap completely on. Squeeze the spray gun trigger. Switch the power button to

Connect one end of the high-pressure hose to the water outlet base on the power washer pump. Connect the other end directly to the base of the spray gun. Hand-tighten all connections firmly; do not use tools, as overtightening can strip the threads or crush the O-rings. Step 3: Connect the Water Supply

ROK power washers typically feature color-coded quick-connect nozzles. Choosing the correct nozzle prevents surface damage. Nozzle Color Spray Angle Best Used For Use with extreme caution

Run water through the garden hose for 30 seconds before connecting it to the machine to flush out dirt.

Before you begin, perform these vital checks to prevent equipment damage:

Move the choke lever to the position (if the engine is cold). Set the engine switch to the ON or RUN position.

Squeeze the spray gun trigger to relieve any built-up backpressure while pulling the starter cord.