Point-n-measure Digital Tape W5746 User Manual

Use the mode buttons (often labeled for Area or Volume) to toggle between simple distance and calculated square/cubic footage.

The device features an automatic power-saving shut-off feature. To turn it off manually, press and hold the power button for approximately 3 to 5 seconds. Operating Instructions Basic Distance Measurement

Slide off the battery compartment cover located on the back of the device.

Even the best tools can sometimes have hiccups. Here are some common problems and their solutions: Point-N-Measure Digital Tape W5746 User Manual

Remove the battery if the device won't be used for over a month.

Press the "Measure" button. The laser will measure the distance from the device to the target.

: The W5746 is splash-resistant but not waterproof. Do not submerge the tool or use it during heavy rain. Always keep the USB-C protective cover sealed when not charging. Use the mode buttons (often labeled for Area

does not just measure length; it automatically calculates, saving time on project estimation. 3.1 Calculating Area (Square Footage) Press the button. Measure the Length (1st measurement). Measure the Width (2nd measurement). The screen will display the total square footage. 3.2 Calculating Volume (Cubic Feet) Press the Volume button. Measure the Length (1st measurement). Measure the Width (2nd measurement). Measure the Height (3rd measurement). The screen will display the total cubic footage. 4. Using the Physical Tape Measure

Pivot 90 degrees, aim at the adjacent wall, and press to capture the width.

What or distance range are you trying to measure? Press the "Measure" button

Since I cannot physically hand you a piece of paper, I have reconstructed the for this specific tool below. This guide covers the features, instructions, and troubleshooting for the Point-N-Measure tape measure.

is not just for distance; it can calculate areas and volumes automatically.