Phison Ps225107ps2307 Mptool - Install ((free))
on the drive. It may also permanently brick the device if incorrect firmware is used. Identify Your Hardware: Use a tool like ChipGenius to confirm your controller is indeed a PS2251-07 (PS2307) and note the (e.g., Toshiba or Hynix memory). Download MPALL:
The progress bar crawled. Lines of status scrolled: mapping table rebuilt, ECC parameters updated, bad-block table repaired. When it finished, the drive re-enumerated as a basic removable disk. He ran a quick filesystem check and restored the partition table from his earlier clone. The photos flickered into view—pixelated thumbnails blossoming into familiar faces.
Plug your corrupted USB drive into a (USB 2.0 ports are more stable for flashing than USB 3.0). Launch ChipGenius as an Administrator. Locate your USB device in the list and inspect the output.
Navigate to the tab and check the box to manually select your Burner and Firmware files. Browse and select the BN07*.BIN and FW07*.BIN files you placed in the folder.
The grid box containing your drive will turn blue and show status updates (e.g., Format , Burner , Write FW ). Do not nudge, disconnect, or power off the machine during this phase. phison ps225107ps2307 mptool install
Note: Ensure your burner and firmware files match your specific NAND memory type (e.g., Toshiba or SanDisk memory chips). Step 2: Install and Extract Phison MPTool
Select your USB drive from the list and look at the information provided. Verify the following fields match: Phison Controller Part-Number: PS2251-07 (PS2307)
If your USB flash drive is corrupted, showing a "Write Protected" error, or appearing as "Phison USB DISK 50X USB Device" with zero bytes of capacity, the controller firmware is likely damaged. For drives powered by the (also known as PS2307 ) controller, the official solution is to use the Phison MPTool (Mass Production Tool).
: Ensure you have checked the "Low Level Format" box under the advanced partition configuration menu in MPTool to wipe the security flags cleanly. on the drive
This comprehensive technical guide will walk you through identifying your controller, downloading the correct MPTool version, installing it, and flashing the firmware to revive your dead USB drive. Part 1: Prerequisites Before You Begin
Click the button on the right side of the interface. Your Phison drive should appear in one of the numbered grid slots, highlighted in yellow or white.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
| Do This ✅ | Avoid This ❌ | |-----------|--------------| | Use a dedicated USB 2.0 hub for flashing | Run MPtool from a network drive or cloud folder | | Save your original firmware dump (if possible) | Interrupt the erase process (hard bricks the drive) | | Run as Administrator every single time | Use MPtool on an SSD or internal hard drive | | Test the drive with after flashing | Share your drive while MPtool is open | Download MPALL:
The progress bar crawled
What version are you running to use this tool? Share public link
Your Phison PS2251-07 drive should appear in one of the numbered grid boxes, flashing a light yellow or white status indicator.
Note: Unzip the downloaded MPALL folder and place both the BN and FW files directly into the main software root directory. Step 3: Configure the MPParamEdit INI File
: Plug in the flash drive. If the tool is compatible, the device information should appear in one of the software interface slots. Configure Settings
