Des Mods en français pour enrichir le gameplay des Sims 4 !
The PZEM-051 is designed to be installed in a standard DIN rail enclosure. The device should be connected to the mains supply and the load circuit in series. The wiring diagram is as follows:
Ensure the shunt wires are tight. Verify you are using a 75mV shunt.
By following the correct installation procedures and understanding its programming, you can unlock the full potential of this device, gaining valuable insights into your electrical systems. Whether you're a seasoned solar installer or a weekend DIYer, the PZEM-051 is an excellent choice for accurate and reliable DC monitoring.
Short press the button to toggle the blue LCD backlight on or off. The meter remembers the last backlight state even after power‑off. peacefair pzem-051 manual
Follow these steps precisely:
is a DC multi-function digital meter designed to monitor four key electrical parameters: voltage, current, active power, and energy. It features a large LCD screen and supports an external shunt (usually 50A or 100A) for current measurement. Technical Specifications 6.5 – 100V DC Rated Power: 100A / 10,000W (Maximum) Accuracy: Grade 1.0 (Voltage/Current) Measurement Ranges:
: Press and hold the button for 5 seconds to save your limits and exit. Troubleshooting Common Issues The LCD Screen Does Not Turn On Verify the voltage source is at least 6.5V DC. Check for reversed polarity on Pin 1 and Pin 2. Current Reading Displays Zero (0.00A) Under Load Check the shunt connection. The PZEM-051 is designed to be installed in
). If either your voltage or current readings are inaccurate due to improper wiring, the power reading will also be incorrect. Verify all wire terminations are clean and tight. To help clarify your installation, let me know:
to increment the flashing digit. It switches digits automatically after 3 seconds of inactivity. Long press (over 5 seconds) to save and exit; it will display " " upon success. Choose Measuring Range (Shunt Selection): Long press until the power area displays " Short press to toggle between modes to match your external shunt. Wiring Instructions The meter must be wired correctly to avoid damage: Power Supply:
Connects directly to the positive terminal of the power supply or battery bank. Verify you are using a 75mV shunt
If you encounter issues, refer to this table for common problems and solutions:
The story of using a PZEM-051 usually follows a specific arc:
Ensure Pin 3 and Pin 4 are wired tightly to the correct sides of the external shunt resistor. Inaccurate or Erratic Power Readings Check for loose terminal block screws.
: Connect Side A of the shunt to Pin 3 (I-) and Side B to Pin 4 (I+). Button Functions and Settings
: There is only one button on the device. Short press : Turns the blue backlight on or off.