Omron M4 Hem 722c1 E Manual -

Used to recall past readings stored in the device's internal log.

Wipe the main monitor body with a soft, dry cloth. For stubborn stains, use a cloth lightly moistened with water and a mild detergent, then wipe dry. Never use alcohol, benzene, or thinners.

Place the cuff 1–2 cm above the elbow crease.

The air tube should run down the center of your inner arm, aligned with your middle finger. Omron m4 hem 722c1 e manual

Wipe the outer plastic casing with a soft, dry cloth. For tougher spots, use a cloth lightly dampened with a mild detergent, then wipe dry. Never submerge the unit in water.

The cuff will begin to inflate automatically. The monitor determines the ideal inflation level based on your personal blood pressure dynamics.

To keep your Omron M4 working for years, follow these maintenance tips directly from the : Used to recall past readings stored in the

Use a damp cloth with mild soap to clean the cuff fabric. Do not wash or submerge the cuff or air tube in water.

: The device is clinically validated to meet European Society of Hypertension (ESH) standards. However, accuracy depends on proper cuff fit and technique.

: Often caused by a loose cuff or moving during measurement. Ensure the cuff is wrapped firmly. Device Won't Start Never use alcohol, benzene, or thinners

Since the official "Omron M4 HEM-722C1-E" manual is hard to find online, here is a list of alternative sources that provide essentially the same operation instructions:

If your device displays an error code instead of a reading, consult this common troubleshooting chart: Error Code / Symptom Potential Cause or E Cuff under-inflated or movement during reading. Sit still, re-wrap the cuff, and measure again. No display when START is pressed Batteries are dead or inserted incorrectly. Replace all 4 AA batteries or check polarities (+/-). Readings are extremely high or low Cuff placement is incorrect or you moved. Review the cuff placement rules and re-test after resting. Air leaks/Cuff won't inflate Tube plug is loose or cuff is damaged. Ensure the plastic plug is pushed completely into the jack. 8. Maintenance, Care, and Safety

Clearly displays systolic pressure, diastolic pressure, and pulse rate simultaneously.