Ivoclar Programat P90 Manual Jun 2026

The display shows both the actual temperature and the setpoint value simultaneously. Ivodent Magyarország Maintenance & Troubleshooting

: Place the object on the firing tray using furnace tongs.

One of the manual’s most valuable assets is its . Examples include:

The speed at which the furnace climbs toward the holding temperature, measured in °C per minute. Ivoclar Programat P90 Manual

community highlight these furnaces as robust and reliable even after decades of use. Ivodent Magyarország Manual & Operational Highlights

: The furnace is designed to be perfectly matched with Ivoclar ceramic materials, ensuring consistent, high-quality results for restorations. Operating the P90 (Based on Manual Data)

Note the exact temperature displayed at the precise moment the silver wire melts and collapses into a ball. The display shows both the actual temperature and

for service centers that still repair the P90. 40 Years Programat - Ivoclar Vivadent - PDF Catalogs

Allows manual or programmed activation of the vacuum pump.

A: Calibration typically involves a silver test or using a calibration set supplied by Ivoclar Vivadent. The manual provides detailed instructions on performing the calibration procedure accurately. Examples include: The speed at which the furnace

Entered B-value (standby temperature) is outside the permissible range of 100°C to 700°C.

| Error Code | Meaning (per manual) | Solution | | :--- | :--- | :--- | | | Thermocouple short circuit or broken wire. | Replace thermocouple (Part # 582926AN). Check wiring harness. | | E3 | Vacuum not reaching required level (-0.95 bar). | Check hose connections, oil level, and vacuum pump diaphragm. | | E5 | Temperature deviation exceeds ±10°C for more than 2 minutes. | Run calibration program. If persistent, replace heating elements. | | Door Error | Safety interlock failure. | Clean door seal. Adjust door latch tension per manual diagram. |

Ivoclar Programat P90 is a landmark dental furnace that first entered the market in 1987, notable for being the first in its line to feature a membrane-sealed keypad

Clean the rubber gaskets on the firing tray lift platform. Inspect the vacuum line for cracks. Replace the pump oil or diaphragms if the pump runs but fails to pull a vacuum.

Place a clean silver calibration wire loop onto a firing tray.