Place a piece of high-purity silver wire across the calibration tray.
At its heart, the P100 is a ceramic furnace designed for high-end dental restorations. Its primary objective is the controlled firing of dental ceramics, such as IPS Empress or various layering porcelains. The manual highlights a sophisticated heating system that ensures the temperature inside the chamber is uniform. In the world of dental ceramics, even a 5-degree variance can result in shade shifts or structural failure (cracking). The P100’s reliability in maintaining this thermal profile is its defining characteristic. Human-Centric Design and Interface
If you are dealing with a specific error message on your display or need help adapting this manual to a particular ceramic line, please let me know. To help me give you the best advice, could you share: The or behavior you are experiencing?
Start the dedicated calibration program from the furnace menu. ivoclar programat p100 manual english
Press the key, input the heating rate (e.g., 60°C/min), and press ENTER .
Use the arrow keys to navigate the menu options.
Another critical section of the manual concerns . The P100 relies on a thermocouple to measure internal temperature accurately. Over time, ceramic residues can build up on the muffle (the heating element chamber), causing temperature deviations of up to 20°C—a catastrophic drift that would melt or under-fire a restoration. The manual details the calibration process using a reference firing pin, as well as the cleaning protocol for the muffle floor and the glass pane. For a dental lab operating under ISO or FDA quality standards, these documented procedures are not suggestions; they are compliance requirements. Place a piece of high-purity silver wire across
| Accessory | Part Number | Compatibility & Notes | | :--- | :--- | :--- | | | 544903 | Used for calibration. Compatible with Programat P100, P200, P300, and P310 furnaces. | | Programat Furnace Tongs | 530665 | Essential for safely placing and removing objects from the hot firing chamber. | | Programat Firing Tray Kit | 598642 | A large honeycomb tray for placing restorations, often used with support pins. | | Programat Firing Tray Metal Pins | 626698 | Support pins (sizes A, B, C) for mounting on the honeycomb firing tray. | | Programat Tong Holder | 607538 | A holder that mounts to the furnace housing for convenient placement of the firing tongs. | | Investment Ring Cooling Rack | 559758 | A grid designed for the optimum cooling of investment rings after pressing. | | IPS Ingot Tongs | 614498 | Special tongs for placing multiple press ingots into a 300g investment ring. |
Place your object onto the firing tray using furnace tweezers.
Press the parameter key you wish to change (e.g., T for Final Temperature). The manual highlights a sophisticated heating system that
Fully automatic vacuum ceramic furnace with microprocessor control.
: Equipped with a QTK heating muffle and a firing plate holder for precise temperature distribution. Safety Features
Interrupts an active firing cycle or stops the cooling process. START VACC: Manually tests or activates the vacuum pump. OPEN / CLOSE: Controls the motorized furnace head movement.
Program the temperature at which the vacuum pump turns on and off. Maintenance and Troubleshooting