Hw 130 Motor Control Shield For Arduino Datasheet

Have you fried an Arduino with one of these? (I have.) Tell your horror story in the comments below.

The L293D chips have built-in diodes and internal clamp diodes for protection against voltage spikes.

Complete Guide and Datasheet for the HW-130 Motor Control Shield for Arduino hw 130 motor control shield for arduino datasheet

The easiest way to program the HW-130 shield is by using the (Adafruit Motor Shield V1 library). Open the Arduino IDE.

// HW 130 with analogWrite() PWM speed control // Remove the ENA and ENB jumpers from the shield first Have you fried an Arduino with one of these

void loop() if (Serial.available()) command = Serial.read();

int IN1 = 4; int IN2 = 5; int IN3 = 6; int IN4 = 7; int ENA = 3; // Jumper on JP2 = full speed int ENB = 11; Complete Guide and Datasheet for the HW-130 Motor

Many users damage their shields or Arduino boards because they ignore proper power supply practices. Follow these rules carefully.

char command;

: 3-pin male headers mapped to Ground, 5V, and Pin 9/10. ⚡ Power Management Configuration