Gordak 952 User Manual Updated Jun 2026
Carefully adjust the trimmer until the external reading matches 300°C. 🧼 Maintenance and Care
Use a dedicated tip thermometer (such as a Hakko 191 or similar) to measure the actual temperature of the soldering tip or hot air stream.
| Parameter | Value | |-----------|-------| | Power consumption | ~700W (total) | | Hot air heater | 500W | | Soldering iron heater | 50W (ceramic) | | Hot air temp range | 100°C – 480°C | | Iron temp range | 200°C – 480°C | | Airflow volume | ~120 L/min (max) | | Display type | Dual 3-digit LED | | Dimensions (approx.) | 190 x 150 x 130 mm | | Net weight | ~2.5 kg | gordak 952 user manual updated
Adjusts the target temperature of the hot air stream.
Always solder in a well-ventilated area or use a dedicated fume extractor to avoid inhaling toxic flux vapors. Technical Specifications Specification Input Voltage 220V AC (or 110V AC depending on regional model) Power Consumption 270W (Hot Air Pump) / 60W (Soldering Iron) Air Pump Type Diaphragm Pump Airflow Capacity 0.3 to 24 L/min (Adjustable) Hot Air Temperature 150°C – 500°C Soldering Iron Temperature 200°C – 480°C Control Panel Diagram and Features The front panel is split into two distinct operating zones: 1. Hot Air Rework Section Carefully adjust the trimmer until the external reading
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. GORDAK 952A 952H 952V SMD rework soldering station
Set the soldering iron dial to exactly 300°C and let it heat for 5 minutes. Always solder in a well-ventilated area or use
Clean flux residue from hot air nozzles using a brass wire brush. Do not force nozzles onto the wand if they do not fit easily.
Both the hot air gun and soldering iron feature fast heating speeds and rapid temperature recovery.
Connect the soldering iron assembly to the 5-pin receptacle on the front panel and tighten the screw collar. Place the soldering iron into its designated metal stand.
Connect the 5-pin soldering iron plug to the front panel receptor and tighten the locking ring. Place the iron tip into the safety holder. Turn on the soldering iron power switch.