Fagor Fi-80 Dishwasher Manual Access

The Fagor FI-80 is designed for simplicity. It features an intuitive control panel that allows for rapid operation in high-volume settings. Preparing the Machine Ensure the tank filter is clean and properly positioned.

Wait for the "ready" indicator light, which confirms the water has reached the proper temperature (usually 60°C for wash and 85°C for rinse). Starting a Wash Cycle

Pre-scrap all wares thoroughly. Open the hood and ensure the overflow tube and filters are correctly seated. fagor fi-80 dishwasher manual

Optimal performance requires incoming hot water between 120°F and 140°F (50°C to 60°C).

Check that filters (front and rear guides) and the overflow tube are correctly seated. The Fagor FI-80 is designed for simplicity

Verify that the site voltage matches the data plate specifications on the front panel of the machine. A dedicated circuit breaker must be utilized.

Allow the dishwasher 20 to 30 minutes to heat up. Do not run a cycle until the wash tank reaches at least 150°F (66°C) and the booster tank reaches 180°F (82°C). Wait for the "ready" indicator light, which confirms

Must be maintained between 20 and 45 PSI (1.4 to 3 bar). If your water pressure exceeds 45 PSI, you must install a pressure-reducing valve.

Must be installed on a level surface. Height is adjustable using the rotating leveling feet Connections: Water (A):

Water hardness should ideally register between 3 to 6 grains per gallon (GPG). Hard water exceeding 7 GPG requires an external water softener to prevent limescale buildup on heating elements.