Ericsson Mini Link Cli Commands Extra Quality -

MINI-LINK# show vlan # Configured VLANs MINI-LINK# show qos queue # Queue occupancy, drops per class MINI-LINK# show ethernet oam # CFM, SLM, LM stats

: Entered via the configure command; this is where parameters for specific interfaces or protocols are modified .

Lists all installed hardware modules, plug-in units (MMU, LTU, NPU), serial numbers, and hardware revisions. show software Use code with caution. ericsson mini link cli commands

admin> odu info admin> odu lldp neighbors admin> odu reset

: (Within config mode) Used to begin OSPF area and routing configurations. MINI-LINK# show vlan # Configured VLANs MINI-LINK# show

show board status : Checks if a specific board is in service or in "repair mode".

Understanding modes is critical. MINI-LINK CLI follows a Cisco-like structure but with Ericsson specifics. admin> odu info admin> odu lldp neighbors admin>

admin> config export tftp://192.168.1.100/config_backup.cfg admin> config import tftp://192.168.1.100/config_new.cfg admin> config compare running startup

The CLI commands are generally sorted into functional classes to simplify navigation: System Status & Monitoring : Commands like show board config show board status

configure radio-link set frequency set capacity set modulation set protected enable exit Use code with caution. show performance radio-link Use code with caution. 4. Ethernet and TN (Traffic Node) Configuration

show system — Displays general node information, uptime, and contact details.