Disco 240 Dmx Controller Manual | [new]

For users just wanting to run pre-programmed "Auto" or "Sound Active" modes, the manual does an adequate job.

Press any to instantly trigger that look. Auto Mode Playback (Chases) Press one or more Chase buttons (1–6) . Press the Auto/Del button. The Auto LED will light up.

: Ensure you are using high-quality DMX cables rather than standard microphone XLR cables. Add a DMX terminator at the end of the chain.

Tap the to select the fixtures you want to adjust. disco 240 dmx controller manual

Move the physical faders (1–12) to set colors, positions, gobos, or brightness. Use the Page Select button to access channels 13–20 if necessary.

(Note: exact labels vary by hardware; use your unit’s panel labels when following steps.)

Located on the right, these trigger programmed sequences or "chases." For users just wanting to run pre-programmed "Auto"

Once you’ve saved multiple scenes, you can play them back automatically: Auto Mode: button so the Auto LED lights up.

: Use the page button to switch between channels 1–8 and 9–16.

Press and hold the button, then press the specific Scene button (1–8) you wish to delete. The LEDs will flash to confirm erasure. Deleting an Entire Bank Enter Program Mode . Select the Bank you want to wipe out. Press the Auto/Del button

Stores up to 240 programmable scenes and 6 banks of chases.

While the manual covers the basics, it leaves out "The Why" and "The How" of advanced troubleshooting.