As of 2025, the current version is DIN EN 60352-2:2020-12 (published December 2020). It supersedes the 2006 edition.
Standard documents are protected by copyright and are typically not available for free legally. You can obtain the official PDF from: : The primary distributor for DIN standards.
In the world of electrical engineering and manufacturing, connection reliability is critical. A single faulty connection can cause system failure, financial loss, or safety hazards. din en 60352-2 pdf
A "crimp" is a solderless joint formed by the controlled plastic deformation of a terminal around a conductor. According to the standard: CETEC Systems Material Integrity
The full title of the standard is:
To legally claim compliance, you must have a licensed copy. Auditors may ask to see your referenced version. Using a pirated PDF puts your certification at risk.
DIN EN 60352-2 standard is the definitive technical framework for "solderless connections," specifically focusing on crimped connections As of 2025, the current version is DIN
“Transient fault,” muttered the electronics technician, Kai. “Ground loop? Cold solder joint?”
Properly centered insulation crimp (if using insulated terminals). Microsection (Crimping Cross-Section Analysis) You can obtain the official PDF from: :
The sea kept its secrets. But her connections never would.
Lena walked to the workshop. In the locked tool cabinet, she found the approved crimp tool: a pneumatic press with interchangeable die sets, last calibrated three months ago. Beside it, a —a precision micrometer block with a slot. For a 0.5 mm² wire, the target crimp height after crimping (the barrel’s compressed outer dimension) was specified in a table in the PDF: typically 1.05 mm ±0.05 mm.