Air Precision Elt 96 Maintenance Manual Verified Page

Unplug the keyed battery wiring harness connector from the main printed circuit board (PCB). Remove the bracket holding the cell pack in place and lift out the depleted battery.

: Maintenance personnel must visually inspect the battery and compartment for any signs of electrolyte leakage or corrosion, which can cause high resistance and equipment failure. Technical Specifications and Verification

Air Precision ELT-96/97 - Three-frequency 121.5 ... - TRAST Inc.

Air Precision ELT 96 (part of the ELT 96/97 series) is a three-frequency emergency locator transmitter primarily maintained under Component Maintenance Manual (CMM) 25-61-02 Core Maintenance Specifications Operating Frequencies: 121.5 MHz, 243 MHz, and 406 MHz. Battery Type: Lithium/Thionyl Chloride cells. Transmission Power: Minimum 5W Peak Effective Radiated Power (PERP) at 406 MHz. Standard Duration: Minimum 48 hours of transmission at 5W. Trast Aero Maintenance Procedures Self-Test:

: Wipe the internal connections with electronic contact cleaner. air precision elt 96 maintenance manual verified

By following these verified maintenance procedures, owners and technicians can ensure the Air Precision ELT 96 is ready to provide reliable performance when it matters most.

For operational readiness, the ELT 96 must conform to international standards such as EUROCAE ED-62 COSPAS-SARSAT specifications. Activation : The device features a

Ensure the aircraft radio is turned to avoid interference.

Summary

To verify the authenticity of the maintenance manual, ensure that it is:

Inspection of the transmitter housing for cracks, corrosion, or secure mounting.

The ELT 96 is approved for use under JTSO2C126 and by the DGAC (France). Maintenance must be documented in the aircraft's technical logbook to ensure compliance with airworthiness directives.

Switch the ELT control toggle from "ARM" or "OFF" to the "TEST" or "ON" position briefly. Unplug the keyed battery wiring harness connector from

: Must be performed every 12 calendar months to check for proper installation and battery corrosion.

Return the switch immediately to the position for flight readiness. Verify that the LED status indicator on the unit flashes the correct "System OK" sequence. 5. Troubleshooting Common Faults Probable Cause Corrective Action LED flashes error code on arming Low battery voltage or self-test failure

Inspect unit mounting tray alignment; bench-test G-switch tolerances. Broken remote wiring or corroded pins